Choose Your Installation Method (A) or (B)

• Clip all four side mounting brackets into their slots using a flat-bladed screwdriver. Ensure they’re securely fitted before sliding product into cavity.

• The mounting slots are in pairs, one on each side diagonally across the product. A bracket  must match A slot and B bracket must match B slot.
• When fitting brackets, ensure the ends are not pushed down into the chassis.

• Check that the fitted elbow is rotated left or right (depending on the direction of the routing), then ensure the venting hose is securely attached to it.

• As you push product in, pull through hoses and cord, ensuring they don’t get kinked or twisted.

If product cannot be pushed in far enough, pull out again and rearrange hoses and cord.  Do not use excessive force, as doing so may squash the hoses and lead to incorrect operation.

1. Open the drawer halfway.  Using a flat bladed screwdriver, prise the gray rubber plug out of the trim moulding.
2. Using a small Philips screwdriver, screw through the trim moulding, securing the side mounting bracket to the cabinetry.  Do not damage the rubber trimseal.
3. Replace the gray rubber plug back into the trim moulding and ensure the trim seal is facing forward.

Repeat for all four brackets.

• After routing the vent hose through and out the hole cutout, attach and secure the vent by tightening the four screws provided.

• Check that the fitted elbow is rotated left or right (depending on the direction of the routing), then ensure the venting hose is securely attached to it.

As you push product in, pull through hoses and cord, ensuring they don’t get kinked or twisted.

If product cannot be pushed in far enough, pull out again and rearrange hoses and cord.   Do not use excessive force, as doing so may squash the hoses and lead to incorrect operation.

Press the release tabs in on either side and push back to release drawer from runners.  Lift drawer off runners.

To prevent kinked hoses
Either sit the drawer down on the left hand side (recommended) or rotate the drawer clockwise, resting it on its side after removal.

The product has three pairs of fixing points:

• After routing the vent hose through and out the hole cutout, attach and secure the vent by tightening the four screws provided.