Operating Instructions
- Last updated
- Save as PDF
Rangehood Control Panel Features
Power | Turns your rangehood ON and OFF. Also allows you to delay shut off. |
|
Fan Speed | Allows you to change the fan speed. | |
Fan Speed Indicator | Indicates the current speed of the fan. 1 is the lowest fan speed and 5 the highest. |
|
Light | Allows you to adjust the level of lighting. | |
Clean Filter Reminder | Button will illuminate red indicating when your filters require cleaning. |
Power
On/Off
Use the button to turn your rangehood ON and OFF. When you turn your rangehood on it will remember the last setting used for your fan speed and lighting level with the following exceptions:
- If the fan was off, it will turn on at fan speed 1.
- If the lighting was off, it will turn on at the lowest lighting level.
The fan and lighting can be turned off independently.
Delayed Shut Off
To Use Delayed Shut Pff:
- Press and hold the
button, the light around the button will blink.
- The fan speed will operate for 5 minutes, starting at the current speed and then at each decreasing speed before turning OFF (the fan will stop and the light will go out).
- To increase the delayed shut off time, press and hold the
button again, you will hear a beep. Each beep indicates the delayed shut off time has been increased by 5 minutes. The maximum delayed shut off time is 25 minutes.
To Cancel Delayed Shut Off:
- Press the
button once.
Fan Speed
- To turn the fan ON, press the
button.
- Press the
button to increase the fan speed.
- To go straight to the MAX fan speed, press and hold the
button. The fan will go straight to speed 5.
- To decrease the fan speed press the
button.
- To turn the fan OFF, press and hold the
button.
Light
- To turn the light ON, press the
button.
- Press the
button again to increase the brightness of the lighting.
- Press and hold the
button to go straight to the brightest lighting.
- Press the
button to decrease the brightness of the lighting.
- To turn the light OFF, press and hold the
button.
Clean Filter Reminder
The clean filterbutton will blink red for 3 seconds when the rangehood is turned
on, then remain illuminated red until the filters are cleaned and the clean filter reminder
is reset.
To Reset The Clean Filter Reminder:
Once the filters have been cleaned and replaced in the rangehood the clean filter
reminder should be reset.
- Press and hold the
button.
Refer to ‘Filter Cleaning’ for details on how to remove and replace your filters.
Remote Control (selected models or optional extra)
Selected models have a remote control provided with the rangehood. This remote can also be purchased as an optional accessory for other models of this rangehood. The remote is designed to make your rangehood easier to use. It allows you to adjust the fan speed and brightness of lighting without touching the rangehood.
Remote Control Features | ||
---|---|---|
Fan Speed | Allows you to adjust the speed of the fan. | |
Light | Allows you to adjust the level of lighting. | |
Battery Indicator | Illuminates when the battery is running low. | |
Signal Indicator | Indicates if the remote control is paired with the rangehood. |
I |
Fan Speed
- To turn the fan ON, press the
button once.
- Press the
button to increase/decrease the fan speed. The fan speed will increase with each button press until it reaches fan speed 5, at the next button press it will return to fan speed 1.
- To turn the fan OFF, press and hold the
button.
Light
- To turn the light ON, press the
button once.
- To increase/decrease the brightness press the
button. The light brightness will increase with each button press until it reaches its highest level, at the next button press it will return to the lowest level.
- To turn the light OFF, press and hold the
button.
Battery Indicator
The battery indictor will illuminate when the battery is running low and needs to be replaced.
Signal Indicator
The signal indicator will illuminate when your rangehood is paired with the remote. The remote can then be used to control the fan speed and brightness of the lighting.
Remote Pairing
- For selected models your remote will be paired with your rangehood in the factory prior to delivery.
- All other models, where the remote has been purchased as an optional extra, the remote will be paired by your Fisher & Paykel trained