Skip to main content
Fisher & Paykel Product Help

Safety Features

 

 

Door Lock

The door of your washer will lock once you touch Screen Shot 2018-01-10 at 2.15.49 PM.png until the machine beeps at the end of the cycle, ensuring safety for you and your family while your machine is operating.

To Unlock the Door During the Cycle:

  • You can open the door to add or remove items during the wash simply by touching the buttonScreen Shot 2018-01-10 at 2.15.49 PM.png .

The door will remain locked until the drum is stationary, if the temperature inside the washer is above 60°C and/or the water level is above the bottom of the door seal (a warning will be displayed in these circumstances, refer to ‘Before you call for service’).
  • Simply touch Screen Shot 2018-01-10 at 2.15.49 PM.png, the machine will pause and the door will automatically unlock if the conditions inside the washer are safe. The Screen Shot 2018-01-10 at 2.15.49 PM.png button and time to go will flash on the screen while the washer is paused. Open the door and remove or add garments. Close the door and touch Screen Shot 2018-01-10 at 2.15.49 PM.png to resume the cycle.

Add a Garment

The ‘Add a Garment’ function can be used to interrupt the cycle to add or remove a garment at any time during the wash part of the cycle (as long as the wash temperature selected is lower than ‘Hot’ temperature). Water in the machine will be drained to a level where the door can be opened, if necessary. Refer to ‘Wash cycle options’ for more information.

Opening the Door During a Power Failure

If there is a power failure during a wash cycle your washer will stop and the door will remain locked. You can unlock the washer door to remove your clothes by opening the pump filter cover at the bottom right of your washer. Simply place a coin or key in the slot and tilt it upwards to lever the cover open, then pull the door release tab.

Screen Shot 2018-01-10 at 2.37.27 PM.png
Manual door opening mechanism

Do not attempt to do this if the water level in the washer is above the level of the door.

When power is restored you will need to restart your machine by simply pressing ‘POWER’. The washer will remember where it was stopped and continue from this point to finish the cycle.

Your Washer also has the Following Protective Measures:

  • Flood protection – turns off valves and turns pump on if a flood condition is detected.
  • Out-of-balance protection – stops and redistributes the load if an unbalanced load condition is sensed, and/or slows the spin speed to compensate.
  • Excess suds protection – pauses to allow suds to break down before continuing the cycle.

 

  • Was this article helpful?