DishDrawer™ 'F' Fault Codes
- Last updated
- Save as PDF
If the display is showing an F fault code, you may be able to clear the fault by resetting the dishwasher - see the steps below. If the fault persists, note down the code before disconnecting the dishwasher from the water and power supplies and Contact Customer Care.
To attempt to clear the F fault code
Press to stop the beeping. Press
again to turn the dishwasher off.
Wait a few seconds. Press again to turn the dishwasher back on. If the fault code has disappeared then the fault has been reset and you can continue to use your dishwasher.
Not sure on which model you have? Click here to Find where your Model Number is located.
Fault Code | Possible Cause | Display |
---|---|---|
F1 |
Flood Detected
Click Here to schedule a visit. |
|
F2 |
Motor Rotor Fault
|
|
F3 |
Temperature Fault You may need to have a tempering valve installed on your water supply, to ensure that incoming water is less than 65oC/149oF, You will require a Service Technician to assist - Click Here to schedule a visit. |
|
F4 |
Heating Element Failed
Click Here to schedule a visit. |
|
F5 |
Lid Motor Fault
Click Here to schedule a visit. |
|
F6 |
Fault with Drying Fan
Click Here to schedule a visit. |
|
F7 |
Fill Valve Fault
Click Here to schedule a visit. |
|
F8 |
Electronics Fault - Motor Controller
Click Here to schedule a visit. |
|
F9 |
Electronics Fault - Wash Controller
Click Here to schedule a visit. |
|
FC |
Electronics Fault - Communication Between Drawers
Click Here to schedule a visit. |
Still Need Help?
You may need assistance from one of our qualified service technicians.
Click on the button below to schedule a visit.
or Contact Us