DishDrawer™ 'A' Fault Codes for DDA & DDC Models

Last updated
Save as PDF

If the display is showing an ‘A’ fault code, follow the steps below to try and fix the issue. If the fault persists, note down the code before disconnecting the dishwasher from the water and power supplies.

Not sure on which model you have? Click here to Find where your Model Number is located.

Fault Code	Possible Cause	*DDA & DDC Models*
A1	Water Supply Fault Ensure the water supply is turned on. Press once to stop the beeping, and then again to clear the fault. Press to resume the wash program.
A3	Drawer Cannot Drain Ensure the drainage hose and connection to pipes are not blocked. Press once to stop the beeping, and then again to clear the fault. Press to resume the wash program.
A6	Fault with the Spray Arm Open the drawer and check the spray arm. If the spray arm has loosened or come off its mounting, re-fit it. Check that it is firmly seated and turns freely, refer Video: How to Check Spray Arm Press once to stop the beeping, and then again to clear the fault. Press to resume the wash program.
A7	Auto Recovery Program Let the auto recovery program run until it is complete. The wash program will resume when the auto recovery program has completed. Check that you are using the right detergent before running another wash program. If the drawer is still filled with foam at the end of the wash program, you will need a Service Technician to assist with this - Click Here to schedule a visit.
A09 *(DDC Models Only)**	Sanitize Cycle hasn't met Temperature Check if the water supply has been turned off or the wash program interrupted. Press once to stop the beeping, and then again to clear the fault. Run the sanitize cycle again.

Still Need Help?

You may need assistance from one of our qualified service technicians.
Click on the button below to schedule a visit.

or Contact Us