Skip to main content
Fisher & Paykel Product Help

Attach Bottom Kickstrip

 

For toe kick installation higher than 4” (102 mm) 

  1. Measure the required height for the bottom grille. On a board, carefuly score/cut the un-required vanes from the bottom of the kick strip grille and discard (refer to A).
  2. Drill Ø 5/32” (4 mm) holes into the dimples of the grille (refer to B).
    Repeat this process for all dimples.
    Screen Shot 2018-01-08 at 8.55.36 AM.png
  3. With the grille tabs facing upwards, align the grille to the bottom of the plinth where the screw holes are located and secure with screws x3 (#8 x 5⁄8 pan head screws) (refer to C).

    Align the air flow divider underneath the grille tabs indicator and clip onto the vanes of the bottom grille (refer to D).
    Screen Shot 2018-01-08 at 8.56.38 AM.png

For toe kick installation at 4” (102 mm)

  1. With the grille tabs facing upwards, align the grille clips to the bottom of the plinth’s slots, then firmly push grille onto the plinth (refer to A).
    Screen Shot 2018-01-08 at 8.57.26 AM.png

  2. Align the air flow divider underneath the grille tabs indicator and clip onto the vanes of the bottom grille (refer to B).
    Screen Shot 2018-01-08 at 8.59.20 AM.png

  • Was this article helpful?