Skip to main content
Fisher & Paykel Product Help

Pre-Aligning Your Product



  • It is important that all four corners of the appliance is supported firmly onto the floor to eliminate any movement.
  • Installing the appliance on a soft, uneven, or not level floor may result in twisting of the product and poor door sealing.
  • Raise the appliance using an 7/16" (11 mm) hex socket or 3/16" (4mm) hex Allen key. One turn of height adjusting nuts is equivalent to 1/16" (1 mm) height travel
    Note: Maximum level travel is 13/16" (20 mm).
  1. Using the front and rear adjustment nuts (A), level the appliance back to front until all tabs located on the installation aiders are in contact with adjacent cabinetry.



Ensure the appliance makes light contact with all tabs on installation aiders. Difficulties in
achieving final alignment can be caused by:

  • Failure to make contact with the installation aiders
  • Too much pressure on the installation aiders causing tabs to bend




2. Gently push the front of the appliance to check the stability, and ensure side gaps are even with enclosure.

Screen Shot 2018-01-08 at 7.20.10 AM.png