Skip to main content
Fisher & Paykel Product Help

80" (2032 mm) Cavity - Attach Anti-Tip Bracket

 

Safety requires refrigerators be stable when door and/or drawer, are open. The anti-tip bracket and fittings supplied must be fitted to the wall of the finished enclosure to withstand a 220.5lb (100 kg) load. This will prevent the possibility of the appliance tipping forward, when door and/or drawer, are open.
Failure to follow instructions can lead to serious injury or death.

 When Fastening with Masonry Plugs and/or Screws:

  • Ensure the screws avoid electrical, gas and water conduits.
  • Ensure the surface the bracket is fastened to withstands a 220.5lb (100kg) load.
  • Ensure light-weight masonry material such as cinder block and new concrete (no curing time) are not used in installation.
  • Do not use metallic materials that may corrode, stain and/or damage the enclosure.

For 80” (2032mm) Cavity Installation

Wooden/Plaster Board Wall Installation

  1. Project the end of the above finished enclosure to the center of the back wall and subtract 2 7/16” (62 mm). This will locate the contact surface between the bracket and the appliance (refer to A).                                                                               

Ensure a structural beam/wall stud closest to the center of the wall enclosure is located.

  1. Fix bracket to the wall with screws x4 (#10 x 40 pan head Phillips screws).  Ensure screws hold tight and the bracket overlaps the appliance when it is positioned (2 3/8” min. (60 mm)) for a secure hold.

80 Antitip wooden plaser image 1.PNG

Profile View

80 Antitip wooden plaser image 2.PNG

Solid Wall Installation

  1. Project the end of the above finished enclosure to the center of the back wall and subtract 2 7/16” (62mm). This will locate the contact surface between the bracket and the appliance (refer to B).
  2. Mark screw locations to drill Ø 1/4” x 1 3/8” (Ø 6mm x 35mm) deep holes. Hammer masonry plugs into the wall until flush x4. Fix bracket to the wall with screws x4 (#10 x 40 pan head Phillips screws). Ensure screws hold tight.

80 Antitip Solid Wall Image 1.PNG

Profile View

80 Antitip Solid Wall Image 2.PNG

Spacer Installation

If a minimum 2 3/8” (60mm) overlap cannot be achieved we recommend fastening a solid spacer (wooden beam etc) behind the bracket.

  1. Ensure the length of the spacer corresponds to the enclosure’s width. Always secure the spacer to existing studs on the enclosure wall (refer to C).
  2. Fix bracket to the spacer with screws x4 (#10 x 40 pan head Phillips screws).  Ensure screws hold tight and the bracket overlaps the appliance when it is positioned (2 3/8” min. (60mm)) for a secure hold.

80 Antitip Spacer  Image 1.PNG

Profile View

 

 

  • Was this article helpful?