Skip to main content
Fisher & Paykel Product Help

Hang Ice and Water Door Panel


For Fisher & Paykel EZKleen stainless steel and DCS stainless steel door panels only.

1. Remove the external display module from inside the product.  Thread the display harness through the door panel cavity.  Ensure the grommet is engaged.


2. Angle top display tabs into the door panel. Ensure the harness is free of pinching. Firmly push against bottom display tabs and insert into the door panel until you feel it clip securely.

Ensure the display is flush with the door panel.

Hang Ice & Water #1.PNG

5. Connect display harness onto the refrigerator door by inserting firmly until you feel it clip securely
(refer to B).

On the external display, enable the dispenser lock, this will help prevent any water from dispensing during water connection. To lock, press the button for 4 seconds. The LED above the button will illuminate.

Hang Ice & Water #3.PNG

3. Remove water tube from holder
on the refrigerator door.

4. Hang door panel onto M8 studs.
Ensure the panel is free to pivot
for water connections (refer to A).


Hang Ice & Water #2.PNG

6. Firmly push the water tube into the spigot behind the door panel
until the marked line is not visible.

Ensure the water tube is routed away from any sharp objects, sharp corners, and not in a location where it can be kinked or squashed when the door panel is secured, (as this will stop water flow).

Flush water filtration system. See 'Ice and Water Initiation'.

Hang Ice & Water #4.PNG
To secure door panel, follow the instructions in the next section: ‘Hang non-Water dispensing door panels’.
  • Was this article helpful?