Skip to main content
Fisher & Paykel Product Help

Assemble Door Panel Set

 

The assembly of Fisher & Paykel (EZKleen stainless steel) and DCS (Stainless steel) door panels and custom door panels are outlined below. To protect the finish of the Fisher & Paykel EZKleen stainless steel and DCS stainless steel door panels, leave protective film on the panels when hanging and remove film only when installation is complete.  If using custom door panels ensure they are prepared as per ‘Custom door panel dimensions’ section.

 

Door Panel

Mounting Handle (refer to A)

For Fisher & Paykel door panel sets or DCS door panel sets, remove the plastic plugs from the handle holes x4. Align the handle to the holes and secure with screw handle x4 (M5 x 25 pan head socket screws).

For custom panels, ensure handle is secured 2 9/16” (65mm) from the inner edge of the panel to the center – this will avoid interference with bracket installation.

Hanging Bracket (refer to B)

For Fisher & Paykel door panel sets or DCS door panel sets, align the bracket to the holes and secure with screws x6 (M5 x 14 Mush Phillips SS).

For custom panels, secure bracket with screws x6 (#8 x 16 Mush washer screws).

Side Brackets & Straps (refer to C)

For Fisher & Paykel door panel sets or DCS door panel sets, align bracket and strap to the holes on the side of the panel and secure with screws x2 (M5 x 14 Mush Phillips SS).


For custom panels, secure bracket with screws x2 (#8 x 16 Mush washer screws).


Repeat this process for all brackets and straps.

Assemble Door Panel #1.PNG

Drawer Door Panel

Mounting Handle (refer to D)

For Fisher & Paykel door panel sets or DCS door panel sets, remove the plastic plugs from
the handle holes x4. Align the handle to the holes and secure with screw handle x4 (M5 x
25 pan head socket screws).


For custom panels, ensure handle screw heads are counter sunk into the back of the panel to avoid interference with hanging bracket.

Hanging Bracket (refer to E)

For Fisher & Paykel door panel sets or DCS door panel sets, align the bracket to the holes
and secure with screws x6 (M5 x 14 Mush Phillips SS).

For custom panels, secure bracket with screws x6 (#8 x 16 Mush washer screws).

Side Brackets & Straps (refer to F)

For Fisher & Paykel door panel sets or DCS door panel sets, align bracket and strap to the 
holes on the side of the panel and secure with screws x2 (M5 x 14 Mush Phillips SS).

For custom panels, secure bracket with screws x2 (#8 x 16 Mush washer screws).

Repeat this process for all brackets and straps.

Assemble Door Panel #2.PNG

 

  • Was this article helpful?