Skip to main content
Fisher & Paykel Product Help

Attach Bottom Grilles

 

For Custom Toe Kick greater than 4” (102 mm)

  1. Measure the required height for the bottom grille. On a board, carefully score/cut the un-required vanes from the bottom of the kick strip grille and discard (refer to A).
  2. Drill Ø 5/32” (4 mm) holes into the dimples of the grille (refer to B).
Screen Shot 2018-01-09 at 2.57.48 PM.png
Cut un-required vanes from the bottom of the grille
  1. With the grille tabs facing upwards, align the grille to the bottom of the plinth where the screw holes are located and secure with screws x3 (#8 x 5/8” pan head screws) (refer to C).

Screen Shot 2018-01-09 at 3.02.49 PM.png
  1. Align the air flow divider underneath the grille tabs indicator and clip onto the vanes of the bottom grille (refer to D).

Screen Shot 2018-01-09 at 3.04.19 PM.png

For Toe Kick Installation at 4” (102 mm)

  1. With the grille tabs facing upwards, align the grille clips to the bottom of the plinth’s slots, then firmly push grille onto the plinth (refer to A).
Screen Shot 2018-01-09 at 3.05.44 PM.png
  1. Align the air flow divider underneath the grille tabs indicator and clip onto the vanes of the bottom grille (refer to B).
Screen Shot 2018-01-09 at 3.06.23 PM.png
  • Was this article helpful?