- Remove packaging
|Foam Tape||2 ft|
|Mounting Bracket (L/R)||2|
|Sheet Metal Screws||14|
- 1/8” Drill
- #2 Phillip Screwdriver
Before installing trim kit, install the convection duct as follows:
Insert the rear section of the duct into the forward section of the duct and install 4 screws supplied (Fig. 01).
Install foam tape on 2 flanges of the rear section of the duct (Fig. 02).
Remove and retain the 2 top screws, left and right, located at the rear vertical edges of the Microwave (Fig. 03).
Place the duct on top of the Microwave and reinsert the 2 screws removed in Step 3 (Fig. 04).