Installation Instructions
Specifications
- The cabinet depth from the outer edge of the face frame to the inside back of the cabinet or wall should be at least 24” (see Fig. 1).
- The warming drawer should be installed into a base cabinet with minimum outside dimensions of 13-1/4” high by 30” wide by 24” deep.
- Power supply required: 120Volts AC; 5 amp min., 15 amp maximum circuit requirement.
|
Cut Out Dimensions
Fig.1 |
Warming Drawer Dimensions (Front View)
Fig.2 |
|
WDV2-30 Dimensions (Side View)
Fig.3 |
WDVI-30 Dimensions (Side View)
Fig.4 |
|
WDVI-30 Dimensions (Custom Panel)
Fig.4a |
|
Mounting Installation
- The lower rear corners of the cabinet need to provide proper support to the back of the warming drawer and the anti-tip mounting clips. A 120 volt AC outlet should be located no further than 36 inches from the back center of the warming drawer.
- The bottom rear section of the cabinet should be made of solid plywood or two 2x4 beams. It holds the anti-tip mounting clips and supports the weight of the warming drawer, which is 90 lbs. (see Figs. 5 and 6). If two 2x4 beams are used, the distance between their centers must be 20” to be able to secure the Warming Drawer.
STEP 1
Use the screws provided and attach the mounting clips. They must be installed for anti-tip safety to the
bottom support at the back. See placement dimensions in the figures below (see Figs. 5 and 6).
STEP 2
Plug power cord into AC outlet. Slide the body onto the anti-tip mounting clips (see Fig. 6).
STEP 3
Use the two supplied 1-1/2” long screws through the two embossed holes (see Fig. 7) to secure the
front of the warming drawer.
|
Fig.5 |
|
Fig.6 |
|
Fig.7 |
Custom Panel Installation of the Integrated Warming Drawer (WDUI/WDVI-30)
STEP 1
Remove drawer as per instructions (see section ‘Care and maintenance’).
STEP 2
Check the dimensions of the front face (see Fig. 8).
STEP 3
Cut the custom panel to the desired dimensions, knowing that the panel must cover the paper front template plus 1/8” on all four sides for a good presentation. The thickness of the custom panel must be greater than 9/16” to allow for clearance for the tips of the screws holding the drawer when the custom panel is mounted.
STEP 4
Center the provided paper front template on the back of the custom panel to drill or cut the clearance areas for the hardware holding the drawer.
The drill sizes and call outs are on the template.
STEP 5
Fasten the custom panel to the front face with the supplied screws as shown in Fig. 8.
|
Fig.8 |
Cabinet Installation
|
Double Wall Oven & Warming Drawer Installation
Fig.9 |
Single Wall Oven, Microwave & Warming Drawer Installation
Fig.10 |
**The floor of the opening should be constructed of plywood strong enough to support the weight of the oven (or use 2 x 4 constructions – see Fig. 1)