Care & Cleaning
- Last updated
- Save as PDF
Manual Cleaning
Always | Never |
---|---|
|
|
What | How | Important! |
---|---|---|
Oven cavity (Models With Out ‘Self Clean’ function only) |
|
|
Oven Cavity (Models With 'Self Clean; function only) |
|
|
Meat Probe | Clean with a solution of mild detergent and hot water, then wipe dry with a microfiber cloth. |
|
Full Extension Sliding Shelf | Wipe with a damp cloth and mild detergent. Do not wipe off or wash away the white lubricating grease (visible when the shelf is extended). | Never leave in the oven during a Self Clean cycle. Do not wash the shelf in the dishwasher, immerse in soapy water, or use oven cleaner on it. Doing so will prevent the slides from running smoothly. |
Grid Broil Rack Broil Pan Wire Oven Shelves |
|
Never leave any of these parts in the oven during a Self Clean cycle (except for the side racks). They will become discolored or damaged. |
Oven Seal (Models With Out ‘Self Clean’ function only) |
Clean with a solution of mild detergent and hot water. | |
Oven Seal |
Do not clean this part. | |
Oven Door Glass | Clean with a mild solution of detergent and warm water. Use a glass cleaner to remove smears. |
|
Removing the Side Racks
Remove the side racks to make cleaning the oven easier.
For models with Self Clean only:
- The side racks can be left in the oven during the self clean cycle.
Always turn off the oven at the wall first. Ensure the oven has cooled down completely before starting.
Remove All Shelves
- Slide out all shelves and remove.
Remove All Shelves |
Remove Both Side Racks
- Unscrew and remove the fixing nut at the front of the side rack. Use a coin to loosen the nut if necessary.
- Pull the side rack toward the center of the oven until the front tab is clear of the fixing nut.
- Slide the side rack forward until the rear prongs are clear of the holes.
Refitting the Side Racks
- Slide the rear prongs of the side rack into the holes at the rear of the oven
- Fit the side rack front tab over the fixing screw.
- Replace the fixing nut. You may use a coin to tighten the nut.
Drop-Down Upper Element (Models with out Self Clean Function Only)
Always turn off the oven at the wall before lowering the upper element. Make sure the oven has cooled down completely before starting.
- To lower the upper element: Pull both the securing clips forward to release the element. The element will now drop down to enable cleaning.
- When you have finished cleaning the oven ceiling, pull the securing clips forward, raise the element and release the clips. Make sure the element is securely held in place.
- The element itself is self-cleaning.
Drop Down Broil Element |
Replacing the Light Bulb
Oven bulb replacement is not covered by your warranty.
- Your oven uses G9 halogen bulbs with the specifications 120V, 50Hz and 25W.
- Always hold the replacement bulb in a soft cloth. Touching the bulb will reduce its lifespan.
- The two oven lights are located behind the opaque glass panels on each side wall of your oven (one on each side).
Changing the Bulb
- Let the oven cavity and broil element cool down before changing the bulb. Before switching off the oven, take note of which light(s) are not working.
Turn the oven off at the wall before continuing.
- Remove the oven shelves and side racks (see ‘Care and cleaning’).
- Pull the glass cover off (if you find this difficult, you can gently prise the cover off using the handle of a spoon or similar in the notches between the glass panel and oven wall while holding the cover to ensure it does not fall).
- Pull out the faulty bulb.
- Holding the replacement bulb in a soft cloth or tissue (touching the bulb with your fingers will reduce its life span) insert it into the socket.
- Replace the glass cover pushing it firmly into place.
Removing & Refitting the Oven Door
Take care, the oven door is heavy.
To Remove the Door
|
|
|
To Refit the Door
|
|
|