Skip to main content
Fisher & Paykel Product Help

Safety and Warnings

Your safety is important to us. Please read this information before using your oven.


Electric Shock Hazard.png

Electrical shock hazard
Before carrying out any work on the electrical section of the appliance, it must be disconnected from the mains electricity supply.
Connection to a good ground wiring system is absolutely essential and mandatory.
Alterations to the domestic wiring system must only be made by a qualified electrician
Failure to follow this advice may result in electrical shock or death.

Fire Hazard.png

Fire hazard
Do not use adapters, reducers, or branching devices to connect this appliance to the mains power supply.
Failure to follow this advice may result in overheating, burning, or fire.

Cut Hazard.png

Cut hazard
Take care - some panel edges are sharp.
Failure to use caution could result in injury or cuts.

Screen Shot 2018-01-05 at 9.13.48 AM.png

Very Heavy
Do not attempt to lift this product unassisted.
Lifting unassisted may cause serious injury.

Screen Shot 2018-01-05 at 9.14.06 AM.png
The models shown in this installation guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please go to our website or contact your local Fisher & Paykel dealer.

Important Safety Instructions!

  • Save these instructions for the local inspectors use.
  • To avoid hazard, follow these instructions carefully before installing or using this appliance.
  • Please make this information available to the person installing the appliance - doing so could reduce your installation costs.
  • This oven is to be installed and connected to the electricity supply only by an authorized person.
  • If the installation requires alterations to the domestic electrical system, call a qualified electrician. The electrician should also check that the socket cable section is suitable for the electricity drawn by the oven.
  • The oven must be grounded.
  • Installation must comply with your local building and electricity regulations.
  • This appliance must be installed and connected to the mains power supply only by a suitably qualified person according to these installation instructions and in compliance with any applicable local building and electricity regulations. Failure to install the appliance correctly could invalidate any warranty or liability claims.
  • If the power supply cable is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person in order to avoid a hazard.
  • A circuit breaker is recommended.
  • Do not use adaptors, reducers or branching devices to connect the oven to the mains electricity supply, as they can cause overheating and burning.
  • Make sure the cavity is completely sealed with no gaps. This is to ensure the oven cooling system functions correctly.

Electrical requirements

  • Connect oven with copper wire only.
  • Do not cut the conduit.
  • A U.L. listed conduit connector must be provided at the junction box.
  • Do not ground to a gas pipe.
  • Do not have a fuse in the grounding or neutral circuit.
  • Fuse both sides of the line.
  • A time delay fuse or circuit breaker is recommended. If using a time delay fuse, then fuse both sides of the line.
  • Flexible armored cable from the appliance should be connected directly to the junction box.
  • Connect directly to the fused disconnect (or circuit breaker box) through flexible, armored or non-metallic sheathed, copper cable (with grounding wire).
  • If codes permit and a separate grounding wire is used, it is recommended that a qualified electrician determine that the grounding path and wire gauge are in accordance with local codes.
  • Was this article helpful?