Skip to main content
Fisher & Paykel Product Help

Installation to the Cabinet


General Information

The oven can be fitted in standard units, minimum width and depth 23" 5/8 (600 mm). Installation requires a compartment as illustrated in figures 5.1 and 5.2.
On the lover side, the oven must lay on supports withstanding the oven weight.
The oven should then be secured by 4 screws fitted into the holes provided at the sides of the oven (Fig. 5.3). If you open the oven door, you will see some screw holes. Remember the housing should not be free standing but be secured to the wall and/or adjacent fittings.


It is essential that when installing your oven, adequate air circulation is available within the installation. Inadequate air circulation may greatly impair the performance of your oven and may affect adjacent cabinets due to an increase in temperature.

Adjust the hinges of cabinet door adjacent to the oven to allow a 5 - 7 mm gap between the furniture door and the oven frame.

Fig. 5.1
Fig. 5.2

Screen Shot 2018-01-05 at 10.29.26 AM.png
Fig. 5.3


Inches mm
A 24" 609.5
B 24" 608.7
C 21" 7/8 max 556 max
D 22" 3/64 max 560 max
E 15/16" 24
F 22" 3/64 560
G 23" 1/32 585
H 1" 31/32 50
I 23" 17/64 591
L 22" 7/16 min 570 min

To ensure internal ventilation, aeration channels must be provided as illustrated in the figures 5.4 and 5.5.

  • The appliance must be housed in heat resistant units.

  • The walls surrounding the oven must be made of heat-resistant material.

  • The adhesive which bonds the plastic laminate to the furniture must withstand temperatures not less than 150°C to avoid de-lamination.

  • The walls of the units must be capable of resisting temperatures of 75°C above room temperature.

    Taking care NOT to lift the oven by the door handle.

Screen Shot 2018-01-05 at 10.39.33 AM.png
Fig. 5.4
Screen Shot 2018-01-05 at 10.40.18 AM.png
Fig. 5.5
To avoid damage to the lower trim please note the following instructions.

The lower trim is designed to allow for good air circulation and the correct opening of the oven door.

To ensure the trim is not damaged due to the appliance being placed on the floor, the appliance should be suitably supported as in above illustrations.

After installation the appliance door should be slowly opened to ensure no damage has occurred.

No responsibility for lower trim damage will be accepted if these instructions have not been followed.

Screen Shot 2018-01-05 at 10.43.53 AM.png
Fig. 5.6
  • Was this article helpful?