Skip to main content
Fisher & Paykel Product Help

How to Attend to a Fault - Designer Models

  1. Last updated
  2. Save as PDF

 

attendtoafault.png

Wash program panel Fault Code Possible Cause of Fault
Screen Shot 2017-06-15 at 1.35.21 PM.png U1 No water – the water supply hasn’t been turned on.
Screen Shot 2017-06-15 at 1.35.27 PM.png U4 Fault in the other drawer preventing the use of this drawer.
Screen Shot 2017-06-15 at 1.35.33 PM.png U6 The spray arm has loosened or come off its mounting, or water pressure is too low.
Screen Shot 2017-06-15 at 1.31.23 PM.png E1 Flood detected.
Screen Shot 2017-06-15 at 1.31.32 PM.png E2 Motor fault.
Screen Shot 2017-06-15 at 1.31.36 PM.png E3 Temperature sensor fault. You may need to have a tempering valve installed on your water supply, to ensure that incoming water is less than 65°C (149°F).
Screen Shot 2017-06-15 at 1.31.40 PM.png E4 Heating element failed.
Screen Shot 2017-06-15 at 1.31.44 PM.png E5 Fault with the internal lid of the dishwasher.
Screen Shot 2017-06-15 at 1.31.48 PM.png E6 Fault with the drying fan.
Screen Shot 2017-06-15 at 1.31.54 PM.png E7 Electronics fault—detergent dispensing system.

Screen Shot 2017-06-15 at 1.31.58 PM.png		 E8 Electronics fault—other systems.
Screen Shot 2017-06-15 at 1.32.02 PM.png E9 Electronics fault—controller.
Screen Shot 2017-06-15 at 1.32.08 PM.png EC Electronics fault—communication between drawers.
  1. Back to top
  • Was this article helpful?

Recommended articles

  1. Appliance
    Clean - Single DishDrawer
    Article type
    Topic
    Manual
    User Guide
  2. Tags
    This page has no tags.