Skip to main content
Fisher & Paykel Product Help

Parts Supplied - All Models

Theses parts are to be used with your Fisher & Paykel Appliance.

Parts Supplied - All Models

1a.png
Drain hose support (1)
2a.png
Drain hose joiner (1)
3a.png
Wire clip (1) (for securing Drain hose joiner)
4a.png
Side mounting bracket kit
(A and B) (2) OPTIONAL
5a.png
Clamp (1)
(for securing Drain hose joiner)
6a.png
Phillips 5⁄8” (16 mm) screws (7)
7a.png
1½ ” (38 mm) bottom fixing screws & metal washers (2)
8a.png
Rubber washer for inlet hose (1) (comes already fitted)
9a.png
Moisture protection tape (1) (to prevent moisture damage)
10a.png
Edge Protector (1)
(If the services hole is through a metal partition the hole must be protected with the Edge protector supplied to prevent damage to the power cord or hoses.)

 

If the Drain hose supplied is not long enough to reach your services, you must use a Drain Hose Extension Kit P/N 525798 which will extend the drain hoses by 11’ 10” (3.6m).

The kit is available from the nearest Fisher & Paykel Authorized Service Center, or Toll free 1.888.936.7872 or www.fisherpaykel.com

 

Additional Parts Supplied with Integrated Models

11a.png
External Venting kit (1)
12a.png
Panel bracket (1) (attached to product)
13a.png
Panel mounting
screws (14)
  • Was this article helpful?