Skip to main content
Fisher & Paykel Product Help

Choose Which Installation Method (A) or (B) is Suitable for Your Cabinetry

 

Recommended Method A_Without Drawer Removal #1.PNG

 

Attached Side Mounting Brackets

  • Clip all four side mounting brackets into their slots using a flat-bladed screwdriver. Ensure they’re securely fitted before sliding product into cavity.
  • The mounting slots are in pairs, one on each side diagonally across the product. A bracket must match A slot and B bracket must match B slot.
  • When fitting brackets, ensure the ends are not pushed down into the chassis.

 

 

Attach Side Mounting Brackets.PNG

 

 

 

Pull Through Hoses & Push into the Cavity

Pull through hoses and push into cavity.PNG
  • As you push product in, pull through hoses and cord, ensuring they don’t get kinked or twisted.

If product cannot be pushed in far enough, pull out again and rearrange hoses and cord. Do not use excessive force, as doing so may  squash the hoses and lead to incorrect operation.

 

Secure to the Cabinetry on the Sides

Secure to the Cabinetry on the sides.PNG

Repeat for all four brackets.

 

 

Alternative Method (B) - Secure by Drawer Removal

Alt Meth B_Secure by Drawer Removal #1.PNG

 

 

Pull Through Hoses & Push Into the Cavity

Meth B_Pull through Hoses.PNG

  • As you push product in, pull through hoses and cord, ensuring they don’t get kinked or twisted.
If product cannot be pushed in far enough, pull out again and rearrange hoses and cord. Do not use excessive force, as doing so may squash the hoses and lead to incorrect operation.

 

Remove the Lower Drawer

  • To prevent kinked hoses Either sit the drawer down on the left hand side (recommended) or rotate the drawer clockwise, resting it on its side after removal.

Meth B_Remove lower drawer.PNG

  • Press the release tabs in on either side and push back to release drawer from runners. 
  • Lift drawer off runners.

 

Secure to the Cabinetry on the Sides

Meth B_Secure to cab on the sides.PNG

 

Refit the Drawer onto the Runners

  • Before refitting the drawer, ensure the hoses are not twisted and the latches at the rear of each drawer runner are facing forward.
  • Lift or rotate counterclockwise the drawer back onto the drawer runners on either side.
  • Pull the release tabs forward on both sides 4” (100mm). Ensure the tabs are fully pulled forward and click into place.

Meth B_Refit drawer onto runners.PNG