Skip to main content
Fisher & Paykel Product Help

Final Checklist

Use this to Check everything has been completed for Installation.


  • Check all parts are installed.
  • Ensure product is level, securely fastened to the cabinetry and opens and closes freely. The drawer must be free to fully close with no resistance from the cabinetry.
  • Ensure inlet hose to water supply has supplied rubber washer fitted, and that it’s tightened a further half turn after seal contact.
  • Ensure any knockouts or plugs in drain connection have been drilled out and drain connection has been made.
  • The drain hose joiner must not support the weight of excess hose material.
  • Keep drain hose as fully extended as possible to prevent sagging. Any excess length of drain hose should be kept on the dishwasher side of the highloop.
  • If connecting the drain hose to the sink trap, ensure the Highloop is a minimum 6” (150 mm) higher than the drain hose joiner.
  • Ensure any packaging or tape securing the racks is removed from the drawer.
  • Turn on the power and water supplies, then open the drawer. You should hear a beep and see a program indicator light up on the internal control panel.
  • Check the spray arms are in place and free to rotate.


  • Add three cups of water into the drawer. Press 2018-01-08_1622.png on the internal control panel until the indicator of the ‘Rinse’ program lights up. Close the drawer and press 2018-01-08_1623.png to start the program.
  • After the Rinse program has finished, ensure the dishwasher has run and drained correctly.
  • Check water supply and drainage connection for leakage.
  • Was this article helpful?