Skip to main content
Fisher & Paykel Product Help

Integrated Models Only - Installing the Front Panel

Installing the front panel for Integrated Models only.

15. Remove bracket from product

WARNING! 

Screen_Shot_2018-01-07_at_10.01.25_PM.png

Electrical Shock Hazard

Before continuing, ensure that the product is disconnected from the power supply.

Failure to follow this warning may result in electrical shock, injury or fire.

2018-01-08_1539.png

16. Attach panel to panel bracket

Use all 14 screws provided as shown.

2018-01-08_1557.png

17. Ground the Panel

2018-01-08_1558.png

WARNING! 

Screen_Shot_2018-01-07_at_10.01.25_PM.png

Electrical Shock Hazard

To ground (earth) the panel bracket, connect the ground (earth) wire from the product to one of the tabs. Any custom metal component (e.g. handle) that extends past the rubber door seal must be grounded (earthed) too.

Failure to follow these warnings may result in electrical shock, injury or fire.

18. Attach panel to product

2018-01-08_1600.png

19.Adjust panel height to align the cabinetry gaps

2018-01-08_1601.png

Integrated models: Ensure that you maintain a minimum of 1⁄16” (2 mm) ventilation gap below the panel.

 

Designer models: Ensure you maintain a minimum of 5⁄16” (8mm) ventilation gap below the panel.

  • Was this article helpful?