Skip to main content
Fisher & Paykel Product Help

Parts Supplied




Parts Suppl_Drain Hose.PNG Parts Req Single  - Drain Hose Joiner.JPG Parts Req Single  - Wire Clip.JPG Parts Suppl_Clamp.PNG Parts Suppl_Side Mounting Bracket.PNG Parts Suppl_Top Mounting Bracket.PNG
Drain hose
support (1)
Drain hose
joiner (1)
Wire clip (1)
(for securing
Drain hose joiner)
Clamp (1)
(for securing
Drain hose joiner)
Side mounting
bracket kit
(A and B) (2)
brackets (2)
Parts Suppl_Philips 5_8 16mm.PNG Parts Req Single  - 38mm Fixing Screws.JPG Parts Suppl_Rubber Washer for Inlet Hose.PNG Parts Suppl_Moisture Protection Tape.PNG Parts Req_Cavity Bracket.PNG Parts Suppl_Edge Protector.PNG
16 mm
screws (7)
38 mm
bottom fixing
screws & metal
washers (2)
Rubber washer
for inlet hose (1)
(comes already
Moisture protection
tape (1)
(to prevent moisture
damage to cabinetry)
Cavity Bracket Kit (1)
(supplied with Tall
Height Models only)
(fitted before installation
in order to conceal
the gap at the top of
the cavity left after
Edge Protector (1)
(If the services hole
is through a metal
partition, the hole must
be protected with the
Edge Protector supplied
to prevent damage to the
power cord or hoses.)
Parts Req - Single_Panel Bracket.JPG Parts Suppl_Philips 5_8 16mm.PNG Parts Req_External Venting Kit.PNG
Panel bracket (1)
& Knock-to-Pause Module (1)
(shipped fixed to product)
Panel mounting screws (6) External Venting kit (1)


Note-Icon.png If the Drain hoses supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit P/N 525798 which will extend the drain hoses by 11’ 10” (3.6m). The kit is available from the nearest Fisher & Paykel Authorized Service Center, or Toll free 1.888.936.7872 or



DishDrawer™ Installation Video

This video provides an overview of what is needed to install a DishDrawer™. It is intended as an overview only of the installation process and is not intended to be used as a guide on how to install a DishDrawer™ yourself.




  • Was this article helpful?