Skip to main content
Fisher & Paykel Product Help

Integrated Models Only - Installing the Front Panels

 

 

18. Remove Bracket from Product

Electric Shock Hazard.png

Electrical Shock Hazard

  • Before continuing, ensure that the product is disconnected from the power supply.
  • Failure to follow this warning may result in electrical shock, injury or fire.

Screen Shot 2018-02-19 at 3.29.23 PM.png

19. Attach Panel to Panel Bracket

Screen Shot 2018-02-19 at 3.30.21 PM.png

20. Ground the Panel

Screen Shot 2018-02-19 at 3.27.19 PM.png

Electric Shock Hazard.png

Electrical Shock Hazard 

  • To ground (earth) the panel bracket, connect the ground (earth) wire from the product to one of the tabs. Any custom metal component (e.g. handle) that extends past the rubber seal must be grounded (earthed) too.
  • Failure to follow these warnings may result in electrical shock, injury or fire.

21. Attach Panel to Product

Screen_Shot_2018-02-19_at_3.30.33_PM.png

22. Adjust Panel Height to Align the Cabinetry Gaps

Screen Shot 2018-02-19 at 3.30.50 PM.png

With the front panels fitted, insert an appropriately sized Philips screwdriver into the hole above the door pin and rotate the panels up or down to align the gaps in your cabinetry.

Repeat on the other side if necessary.

The panel has a maximum travel of 1⁄16” (2 mm) up or down.

Ensure that you maintain a minimum of 1⁄16” (2 mm) ventilation gap below the panel.

  • Was this article helpful?