Skip to main content
Fisher & Paykel Product Help

Installing Custom Front Drawer Panels

 

 

 

Remove Both Panel Brackets from Product

WARNING! 

Electric Shock.PNG

Electrical Shock Hazard

  • Before continuing, ensure that the product is disconnected from the power supply.
  • Failure to follow this warning may result in electrical shock, injury or fire.

 

Custom Front Drawer Panels_Remove both panel brackets_1.PNG

Remove side pins and gently pull off the panel bracket slightly.
Repeat for the other drawer.

Custom Front Drawer Panels_Remove both panel brackets_2.PNG

  1. Disconnect the Earth Wire from the bracket
  2. Unplug the knock sensor from the controller.

Repeat for the other drawer.

 

Remove the Knock-To-Pause Module

591386B_DD Remove Knock-to-Pause.png

Remove the Knock-to-Pause module from the back of the bracket.
Repeat for the other bracket.

 

Attach Custom Panels to Panel Brackets

Custom Front Drawer Panels_Attach custom panels to panel brackets.PNG

After the steps described above are carried out, the pictures will be immediately deleted without any additional confirmation queries. 

 

Attach Knock-to-Pause Modules to Custom Panels

Custom Front Drawer Panels_Attach Knock to pause modules.PNG

 

Ensure the Knock-To-Pause module is orientated correctly before attaching.
Ensure the module is centralized in the holes and not in contact with the bracket.

Attach the Knock-To-Pause module to the back of the custom panel through the 3 holes cut into the panel bracket as shown.
Use all 3 screws provided.
Repeat for the other module. 

 

Connect the Knock-to-Pause Module to the Controller

Custom Front Drawer Panels_Connect knock-to-oause module.PNG

Repeat for the other drawer.

 

Reconnect the Earth Wire to the Panel Bracket

 

WARNING! 

Electric Shock #2.PNG Electrical Shock Hazard
  • To earth the panel bracket, connect the earth wire from the product to one of the tabs.
  • Any custom metal component (e.g. handle) that extends past the rubber seal must be earthed too.
  • Failure to follow these warnings may result in electrical shock, injury or fire.

591386B_DD Reconnect Earth Wire to Panel Bracket.png

Reconnect the Earth Wire to the Panel bracket. 
Repeat for the other drawer.

 

Attach Custom Panels to Product

591386B_DD Attach Custom Panels to product.png

Push the Custom Panel on to the drawer and reinsert the side pins on each side.
Repeat for the other drawer.

 

Adjust Custom Panel Height to Align Cabinetry Gaps

591386B_DD Adjust Custom Panel Height.png

With the front panels fitted, insert an appropriately sized Philips screwdriver into the hole above the side pin and rotate the panels up or down to align the gaps in your  cabinetry.
Repeat on the other side if necessary.


Each panel has a maximum travel of 1/16” (2mm) up or down.

Ensure that you maintain a minimum of 5/16” (8mm) ventilation gap between the upper and lower panels.