Skip to main content
Fisher & Paykel Product Help

Fault codes

When a continuous series of beeps is sounded, all the lights turn off on the control panel and a number appears on the display, a fault has occurred. The washer will automatically enter this mode if a fault occurs. The fault code will be displayed as a number on the digital display. To stop the sound, touch any button and perform the following steps:

  1. Turn your washer off at the power point.
  2. Wait 1 minute and turn it back on.
  3. Remove your wash load.
  4. Perform a ‘Rinse’ cycle.
  5. If the washer will still not work you will be required to call a Fisher & Paykel trained and supported service technician to arrange service (refer to the ‘Customer Care’ section). Record the fault code number displayed and the serial number of your washer (located on the rear of the washer) before calling. The fault code will indicate to the repairer what the problem could potentially be.

If a fault code is being displayed, you can still turn your washer off by touching ‘POWER’ .

  • Was this article helpful?