The washer will automatically enter this mode if a fault occurs. The fault code will be displayed as a number on the digital display. To stop the sound, touch any button and perform the following steps:
- Turn your washer off at the power point.
- Wait 1 minute and turn it back on.
- Remove your wash load.
- Perform a ‘Rinse’ cycle.
- If the washer will still not work you will be required to call a Fisher & Paykel Authorised Repairer to arrange service (refer to the ‘Customer Care’ section). Record the faultcode number displayed and the serial number of your washer (located on the rear of the washer) before calling. The fault code will indicate to the repairer what the problem could potentially be.
If a fault code is being displayed, you can still turn your washer off by touching ‘Power’ .