First use
Fig. 15 Control panel
| 1 Control buttons 2 Clock display 3 Temperature dial 4 Function dial 5 Front left cooking zone dial |
6 Rear left cooking zone dial 7 Rear right cooking zone dial 8 Front right cooking zone dial 9 Function indicator light 10 Temperature indicator light |
Buttons
 |
sets the timer |
 |
sets the cooking time |
 |
sets the stop time for automatic cooking |
 |
set the oven temperature / select Celsius |
 |
set the oven temperature / Fahrenheit |
 |
decreases the time and temperature |
 |
increases the time and temperature |
Fig. 16 Clock display and control buttons
Illuminated symbols
|
If the display shows |
It means that... |
For more information |
|---|---|---|
flashing  |
The clock needs to be set. |
See instructions below. |
 steadily lit |
The oven is set for automatic cooking. |
See section ‘Automatic cooking’ |
| flashing and beeping |
Automatic cooking has finished |
See section ‘Automatic cooking’ |
 steadily lit |
The timer is set |
See section ‘Using the electronic timer’ |
 steadily lit |
The oven is heating up |
See section ‘Using your oven’ |
To set the clock
When the power to the appliance is turned on or restored after a power failure will flash in the display.
- Press and together - the display will stop flashing. The clock is now set for .
- Press and together again to change the time. The display will flash.
- Press and to set the time. After a few minutes the display will be steadily lit, showing the time is set.
To change the time
-
Press
and together. The display will flash. -
Press
and to set the time.
After a few seconds the display will remain steadily lit, showing the time is set.
Remove the side racks to fit the Catalytic panels (if not already fitted)
-
Remove all shelves and trays.
-
For easier access to the fixing screws, you may remove the oven door first. See ‘Removing and refitting the oven door’ in Care and Cleaning.
-
Remove the side racks on both sides:
-
Using a small coin or a flat-head screwdriver, loosen and remove both fixing screws.
-
-
Gently remove the side rack.
Fig. 17 Removing the side racks
Fitting the Catalytic panels
-
Fit the catalytic panel. When fitting the catalytic panel make sure that - the arrows are pointing upwards
-the panel with the hole in it is on the right oven wall.
Refitting the side racks
- To refit the side racks - make sure that they are the right way up, as in the illustrations, and that you tighten the fixing screws.
- If not already fitted, fit the telescopic sliding shelf supports. See “Care and cleaning’ for instructions.