Care and cleaning

Stainless steel base

After every use

1. Soak any stubborn stains under a hot soapy cloth.
2. Wipe the soiling off with a cloth using a mild household detergent or stainless steel cleaner.
3. Wipe with a clean damp cloth.
4. Wipe the surface dry with a microfibre cloth.
5. For extra shine, use a suitable stainless steel polish.
   • Hard water spots can be removed with household white vinegar.

• Do not use abrasive cleaners, steel soap pads or sharp objects on stainless steel.
• Always read the label to make sure that your stainless steel cleaner does not contain chlorine compounds as these are corrosive and may damage the appearance of your cooktop.
• Always rub the stainless steel in the direction of the grain.
• The graphics are etched onto the steel by laser and will not rub off.

Control dials

As needed

1. Wipe with a damp cloth and mild detergent. Stainless steel cleaner can be used on the top surface of the dials only.
2. Dry thoroughly with a soft cloth.

Do not use oven cleaner on the dials, as doing so may damage their coating.
Do not clean in dishwasher. These parts are not dishwasher safe.

Burner caps
and rings, flame spreaders, pan supports, wok
stand

As needed, but at least once a month

1. Remove the parts that you wish to clean.
   See the the illustrations following this chart.
2. Soak stubborn stains in a solution of biological clothes washing detergent or powdered dishwasher detergent.
3. Clean the parts in hot soapy water. Use a stiff nylon brush or straight-ended paper clip to clear the flame ports.
   
4. Rinse in warm water.
5. Dry thoroughly.
6. Replace the parts correctly, as shown in the drawings following this chart.

• Make sure you keep the flame ports clear. Soiling from food spillage may clog these and cause ignition problems or uneven flame patterns.
• Remove stains left by food or spillovers as soon as possible. If left to burn on, they may be difficult to remove or even permanently discolour these parts.
• Before replacing the burner parts, make sure that they are completely dry. Wet burner parts may result in an irregular flame.
• Before lighting a burner you have reassembled, check that all of its parts have been positioned correctly. Incorrect assembly can cause dangerous irregular flames and ignition problems.

Ignitor and probe

At least once a month

Clean these very carefully using a toothbrush dipped into methylated spirits.

A clean ignitor ensures trouble-free sparking. Check the ignitor regularly to make sure it is clean.

All gas components of the cooktop

Once every 3-4 years

• Contact your local Authorised Repairer to perform a thorough check on all gas components of the cooktop.
• For Authorised Repairer details, see your Service & warranty book or contact Customer Care.

• All checking and maintenance must be performed by a suitably qualified person.
• If the gas is connected with a flexible hose, checking should include inspecting the entire length of the flexible hose assembly for any sign of wear or damage.