Gas Connection

If connecting the gas with a flexible hose: Ensure the hose is long enough to allow for removal of cooktop for servicing.

NG Models

Make sure to fit the supplied regulator.
Adjust to obtain a test point pressure of 1 kPa with all burners operating at highest setting.

LPG Models

Make sure to fit the supplied test point adaptor.
Make sure the supply pressure is regulated to 2.75 kPa, with all burners operating at highest setting.

Make sure the connection point will be accessible with the cooktop installed.
To enable the gas supply to be readily shut off by the customer, make sure the connection is fitted with an isolating valve close to the cooktop.
A manual shut-off valve must be installed in an accessible location in the gas line external to the appliance for the purpose of turning on or shutting off gas to the appliance.
Gas connection to the product must use the nipple supplied with a 1/2” BSP external thread. The supplied gas pressure regulator must be installed where it will be accessible for adjustment.

Ensure the hose is long enough to allow for removal of cooktop for servicing.
Make sure the connector is located as shown in 'Clearance Dimensions'.
The hose assembly must be with an Rp 1/2” (ISO 7-1) female thread connection (AS/NZS 1869 Class B or D certified).
The hose assembly must be as short as practicable (maximum length of 1.20m) and comply with the relevant AS/NZS5601.1 requirements.
The hose must not be kinked, subjected to abrasion or permanently deformed.
The hose must not be near or in contact with any hot surfaces (e.g. base of metal hotlplate, flue, or chassis of undercounter oven etc.)