Skip to main content
Fisher & Paykel Product Help

Flush Mounting Installation (Not Recommended)

We do not recommend flush mounting and sealing as servicing requires the cooktop to be removed from the benchtop. The owner carries all risk for flush mounting the cooktop.

Refer to ‘When you you install the appliance’ in the Safety and Warnings section before you flush mount this appliance.

Electrical connection is made at the right rear.

Property

Size (mm)

  1. Overall height of product (excluding burners, dials and pan supports)

79

  1. Overall width of product

900

  1. Overall depth of product

530

  1. Height of chassis (below top of counter)

76

  1. Width of chassis

860

  1. Depth of chassis

487

  1. Overall width of routered recess

905

  1. Width of cutout

875

  1. Overall depth of routered recess

535

  1. Depth of cutout

494

  1. Corner radius of cutout

10

  1. Corner radius of routered recess

max. 5

  1. Height of routered recess

3

  1. Distance from top of counter to center of gas inlet on product

76

  1. Distance from edge of chassis to gas inlet on product

22

  1. Minimum clearance below top of benchtop to:
    • rear top of oven* installed below cooktop or cabinetry thermal protection barrier

81
81

  1. Router the benchtop to the specified depth.

  1. Fit the clamping brackets.

REPEAT ON ALL THE OTHER SIDES

(Total 6 brackets)

  1. Mask off the area to be siliconed

  1. Apply silicone.

Ensure silicone does not leak underneath the steel edge.

  1. Wipe off excess silicone.

  1. If removing product, cut around the silicone.

  • Was this article helpful?