Skip to main content
Fisher & Paykel Product Help

Safety and Warnings

Use this built-in oven only for the intended purpose as described below and in your user guide.


Electrical shock hazard

Always disconnect the appliance from the mains power supply before carrying out any maintenance or repairs. Connection to a good earth wiring system is essential and mandatory. Alterations to the domestic wiring system must only be made by a qualified electrician.

Failure to follow this advice may result in electrical shock or death.

Fire hazard

Do not use adapters, reducers, or branching devices to connect this appliance to the mains power supply. Failure to follow this advice may result

Cut hazard

Take care - panel edges are sharp.

Failure to use caution could result in injury or cuts.


Important safety instructions!

  • To avoid hazard, follow these instructions carefully before installing or using this appliance.
  • Please make this information available to the person installing the appliance - doing so could reduce your installation costs.
  • This appliance must be installed and connected to the mains power supply only by a suitably qualified person according to these installation instructions and in compliance with any applicable local building and electricity regulations. Failure to install the appliance correctly could invalidate any warranty or liability claims.
  • The oven must be earthed.
  • If the power supply cable is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person in order to avoid a hazard.

Before you install the oven, please make sure that

  • it will be lifted by two people.
  • the oven will rest on a flat surface that can support its weight.
  • the benchtop and oven cavity are square and level, and are the required dimensions.
  • the height from the floor suits the customer.
  • the oven door can open fully without obstruction.
  • a suitable isolating switch providing full disconnection from the mains power supply (under overvoltage category III conditions) is incorporated in the permanent wiring, mounted and positioned to comply with the local wiring rules and regulations. The isolating switch must be of an approved type and provide a 3 mm air gap contact separation in all poles (or in all active [phase] conductors if the local wiring rules allow for this variation of the requirements).
  • the electrician provides sufficient free length of power supply cable to reach from the bottom rear of the cavity to at least 1.5 metres in front of the bottom edge of the opening. The cable may enter the cavity from the side, top or bottom, but top entry must be at the rear of the cavity.

When you install the oven

  • Do not seal the oven into the cabinetry with silicone or glue. This makes future servicing difficult. Fisher & Paykel will not cover the costs of removing the oven, or of damage caused by this removal.
  • Use the supplied screws to secure the oven to the cabinetry. Do not over-tighten the screws.
  • Make sure that the power supply cable will not touch any hot metal parts.
  • Make sure that the isolating switch will be easily accessible by the customer.
  • Do not stand on the door, or place heavy objects on it.
  • Do not lift the oven by the door handle.
  • Take extra care not to damage the lower trim of the oven. We suggest you place the unpacked oven onto wooden blocks or similiar supports.
  • When handling the oven, take care not to damage the door sensor lever (near the top right corner of the oven seal).
  • Use easy-to-clean finishes for the wall surfaces surrounding the oven, so that cooking fume staining resulting from using the oven is easy to remove.
  • Was this article helpful?