Skip to main content
Fisher & Paykel Product Help

Safety and Warnings

Use this built-in oven only for the intended purpose as described below and in your user guide.


Screen Shot 2017-06-28 at 4.14.16 PM.png

Electrical shock hazard

  • Before carrying out any work on the electrical section of the appliance, it must be disconnected from the mains electricity supply.
  • Connection to a good earth wiring system is absolutely essential and mandatory.
  • Alterations to the domestic wiring system must only be made by a qualified electrician.
  • Failure to follow this advice may result in electrical shock or death.

Fire hazard

  • Do not use adapters, reducers, or branching devices to connect this appliance to the mains power supply.
  • Failure to follow this advice may result in overheating, burning, or fire.

Cut Hazard

  • Take care - panel edges are sharp.
  • Failure to use caution could result in injury or cuts.

Double Oven Models2017-08-04_1318.png
409 lb
186 kg


Very Heavy

  • Do not attempt to lift this product unassisted.
  • Lifting unassisted may cause serious injury.

Single Oven Models2017-08-04_1318.png
242 lb
110 kg


Important Safety Instructions!

  • Save these instructions for the local inspectors use.
  • To avoid hazard, follow these instructions carefully before installing or using this appliance.
  • Please make this information available to the person installing the appliance - doing so could reduce your installation costs.
  • This appliance must be installed and connected to the mains power supply only by a suitable qualified person according to these installation instructions and in compliance with any applicable local building and electricity regulations. Failure to install the appliance correctly could invalidate any warranty or liability claims.
  • If the installation requires alterations to the domestic electrical system, call a qualified electrician. The electrician should also check that the socket cable section is suitable for the electricity drawn by the oven.
  • The oven must be earthed.
  • If the power supply cable is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person in order to avoid a hazard.
  • Isolating switch: make sure this oven is connected to a circuit which incorporates an isolating switch providing full disconnection from the power supply in accordance with the wiring rules.
  • Do not use adaptors, reducers or branching devices to connect the oven to the mains electricity supply, as they can cause overheating and burning.
  • Make sure the cavity is completely sealed with no gaps. This is to ensure the oven cooling system functions correctly.
  • Was this article helpful?