Introduction

Before You Start

• Make sure the installer has completed the ‘Final checklist’ in the Installation instructions.
• Read this guide, taking special note of the ‘Safety and warnings’ section.
• Remove all packaging and dispose of it responsibly. Recycle items that you can.
• Fit the side racks and catalytic panels (see ‘Fitting the side racks and catalytic panels’).
• We recommend you then condition the oven, using the instructions following.

Not all accessories are provided with all models. To purchase other accessories, contact your nearest Fisher & Paykel Authorised Service Centre, Customer Care or visit our local website listed on the back cover.

	Oven Features may vary
Control panel Oven vent louvres Oven light Sliding shelf support Wire shelf Side rack Step down oven wire shelf Oven door and handle Oven seal Drip channel	Accessories: Grill rack Grid Roast Dish Flat baking tray Catalytic panels (suitable for some models only).

Fitting the Side Racks & Catalytic Panels (some models only)

Fit the Side Racks

1. Slide the rear prongs of the side rack into the holes at the rear of the oven
2. Fit the side rack front tab (and catalytic panel if fitted) over the fixing screw.
3. Replace the fixing nut. You may use a coin to tighten the nut.

Catalytic Panel (if fitted)

 

Fitting the Sliding Shelf Supports

Compact ovens only: The sliding shelf supports cannot be used on shelf positions 3 and 4.

To Fit Ensure the slides are the correct way around (the front of the slide has the triangular shaped tab as shown). Fit the top of the clips over the side rack, the front clip should be fitted as close to the front of the side rack as possible. Make sure the rear clip has engaged. Rotate the slide down and ‘click’ the bottom of the clips into place.

Front of Left Hand Slide

Front of Right Hand Slide