Skip to main content
Fisher & Paykel Product Help

Fault codes

If the dishwasher malfunctions, it will display a fault code and beep. Check the table below to see if you can correct the fault yourself before contacting Fisher & Paykel Customer Care.

If the dishwasher still will not work, or shows any other fault code

  1. Press  to turn the dishwasher off and wait a few minutes.

  2. Press  again to turn the dishwasher back on.

    If the dishwasher still does not function and/or the problem persists, disconnect the dishwasher from the power supply, turn the water supply off, then contact Fisher & Paykel Customer Care with the fault code information.

Fault Codes And Descriptions

Possible Causes

What To Do

Drain fault

Drain hose is crimped or bent.

Check the drain hose and straighten if needed.

The waste water is not draining out.

Ensure that the drain hose is connected in accordance with the installation instructions.

no water

Water tap not turned on.

Ensure the water is connected and turned on. Press   to restart the dishwasher.

Insufficient water supply pressure.

Check household water pressure.

Water inlet hose is crimped or bent, so no or not enough water gets to the dishwasher.

Check the water inlet hose and straighten if needed. Press  to restart the dishwasher.

Drain hose is not connected correctly.

Ensure that the drain hose is connected in accordance with the installation instructions.

Flooding

Flood switch activated.

Turn the dishwasher OFF and ON again. If fault persists, turn water off and disconnect the dishwasher from the power supply. Call Customer Care.

Water flow error.

Switch dishwasher OFF and ON again. If fault persists call Customer Care.

Electronics error.

Switch dishwasher OFF and ON again. If the fault persists call Customer Care.

Motor Fault.

Switch dishwasher OFF at
the power supply. Wait a few moments and switch ON again. If the fault persists, turn water off and disconnect from the power supply. Call Customer Care.

  • Was this article helpful?