Skip to main content
Fisher & Paykel Product Help

Integrated Models with Badge (GB IE) Only - Installing the Front Panel & Badge Controls

  1. Last updated
  2. Save as PDF
Details how to install the front panel for integrated model with badge only.

Integrated Models with Badge (GB IE) Only - Installing the Front Panel & Badge Controls

1. Determine Badge Cutout Location

WARNING!


shock.png

 

Electrical Shock Hazard

  • Before continuing, ensure that the product is disconnected from the power supply.
  • Failure to follow this warning may result in electrical shock, injury or fire.

install19_480-fixed.jpg

2. Remove Bracket & Disconnect Badge

2017-07-28_1544.png 2017-07-28_1545.png

3. Route Badge Wiring through Panel

install21.png

4. Attach Panel to Panel Bracket

Important-Icon.png

Use all 14 screws provided as shown.

2017-07-28_1546.png

Align bottom of panel with bottom of bracket

5. Reattach Badge & Earth the Panel

2017-07-28_15506954.png

WARNING!


shock.png

 

Electrical Shock Hazard

  • Connect the integrated badge earth wire to one of the two tabs provided on the panel bracket. To earth the panel bracket, connect electrical shock, injury or fire. the earth wire from the product to the other tab. Any custom metal component (e.g. handle) that extends past the rubber seal must be earthed too.
  • Failure to follow these warnings may result in electrical shock, injury or fire.

6. Attach Panel to Product

2017-07-28_1346356.png

When refitting the door pins, ensure they are orientated as shown.

We recommend pushing the drawer runners back 100 mm before attaching the panel. Once the panel is fiited, ensure the runners are fully back into position and the release tabs on both sides are reset fully.

Important-Icon.png

Ensure the rubber seal between the drawer and panel is kept in place.