Dishwasher and Ø 38 mm Standpipe
- Screw Drain hose support to back wall at correct height.
- If space is limited for fixing, push hose through drain hose support to required height.
 |
Ensure that drain hose is installed as close to the underside of the benchtop as possible. This will ensure no waste re-enters the drain hose in the event of poor flow or a blockage in the plumbing. |
Ensure the drain hose does not extend into water retained in the trap; an
air gap is required to prevent waste water from siphoning back into the tub.
|
Ensure that drain connection complys with local plumbing regulations. |
|
Dishwasher Using Drain Hose Joiner onto Sink Trap/Waste Tee
- Screw Drain hose support to back wall at correct height.
- If space is limited for fixing, push hose through drain hose support to required height
- Supplied drain hose joiner to suit 19 mm waste tee.
Ensure drain hose is routed straight to joiner. Remove excess drain hose material if necessary. Do not shorten the inlet hose.
|
Do not connect the drain hoses to a Waste Disposal Unit, as this type of connection may lead to a blockage in the drain hoses. |
|
