- Screw Drain hose support to back wall at correct height.
- If space is limited for fixing, push hose through drain hose support
- to required height.

 |
Ensure that drain hose is installed as close to the underside of the benchtop as possible. This will ensure no waste re-enters the drain hose in the event of poor flow or a blockage in the plumbing. |
Ensure the drain hose does not extend into water retained in the trap; an
air gap is required to prevent waste water from siphoning back into the tub.
 |
Ensure that drain connection complys with local plumbing regulations. |
|
- Screw Drain hose support to back wall at correct height.
- If space is limited for fixing, push hose through drain hose support to required height.
- Supplied drain hose joiner to suit 19 mm waste tee.
- Ensure drain hose is routed straight to joiner. Remove excess drain hose material if necessary. Do not shorten the inlet hose.
.JPG?revision=1)
 |
Do not connect the drain hoses to a Waste Disposal Unit, as this type of connection may lead to a blockage in the drain hoses. |
|