Choose your Installation Method A or B
Recommended Method (A) - Secure without Drawer Removal
(Frameless Cabinetry Only)
Attach Side Mounting BracketsClip all four side mounting brackets into their slots using a flat-bladed screwdriver. Ensure they’re securely fitted before sliding product into cavity. The mounting slots are in pairs, one on each side diagonally across the product. A bracket must match A slot and B bracket must match B slot. When fitting brackets, ensure the ends are not pushed down into the chassis. |
Pull Through Hoses & Push into the Cavity
As you push product in, pull through hoses and cord, ensuring they don’t get kinked or twisted. |
If product cannot be pushed in far enough, pull out again and rearrange hoses and cord. Do not use excessive force, as doing so may squash the hoses and lead to incorrect operation.
Secure to the Cabinetry on the Sides |
Repeat for all four brackets |
Alternative Method (B) - Secure by Drawer Removal
|
Pull Through Hoses & Push into the Cavity |
Remove the Lower Drawer |
||
As you push product in, pull through hoses and cord, ensuring they don’t get kinked or twisted.
|
To prevent kinked hoses Either sit the drawer down on the left hand side recommended) or rotate the drawer clockwise, resting it on its side after removal. (3) Press the release tabs in on either side and push back to release drawer from runners. Lift drawer off runners. |
Secure to the Cabinetry on the Sides |
Refit the Drawer onto the Runners |
The product has three pairs of fixing points: (1) Two pairs of formed brackets on either side of the chassis (use 16 mm screws) (2) Ensure the sound insulation is repositioned correctly. (3) A pair of fixing holes either side on the bottom (use 38 mm fixing screws & washers) |
Before refitting the drawer, ensure the hoses are not twisted and the latches at the rear of each drawer runner are facing forward. Lift or rotate anti-clockwise the drawer back onto the drawer runners on either side. Pull the release tabs forward on both sides 100 mm. Ensure the tabs are fully pulled forward and click into place. |