Skip to main content
Fisher & Paykel Product Help

Choose your Installation Method A or B

 

(Frameless Cabinetry Only)

 

Install Method A - Single.JPG

Attach Side Mounting Brackets

Clip all four side mounting brackets into their slots using a flat-bladed screwdriver. Ensure they’re securely fitted before sliding product into cavity.

Install Method A Single - Attach side brackets.JPG

The mounting slots are in pairs, one on each side diagonally across the product. A bracket must match A slot and B bracket must match B slot.

When fitting brackets, ensure the ends are not pushed down into the chassis.

Pull Through Hoses & Push into the Cavity

 

Install Method A Single - Pull through hoses.JPG

As you push product in, pull through hoses and cord, ensuring they don’t get  kinked or twisted.

If product cannot be pushed in far enough, pull out again and rearrange hoses and cord. Do not use excessive force, as doing so may squash the hoses and lead to incorrect operation.

 

Secure to the Cabinetry on the Sides

Secure to Cabinetry on Sides (1).JPG

  1. Open the drawer halfway.  Using a flat bladed screwdriver, prise the grey rubber plug out of the trim moulding.
  2. Using a small Philips screwdriver, screw through the trim moulding, securing the side mounting bracket to the cabinetry.  Do not damage the rubber trimseal.
  3. Replace the grey rubber plug back into the trim moulding and ensure the trim seal is facing forward.

Secure to Cabinetry on Sides (2).JPG

Repeat for all four brackets

 

Alternative Method (B) - Secure by Drawer Removal

Install Method B - Single.JPG

Pull Through Hoses & Push into the Cavity

Remove the Lower Drawer

Install Method B Single  - Pull through hoses.JPG

As you push product in, pull through hoses and cord, ensuring they don’t get kinked or twisted.

If product cannot be pushed in far enough, pull out again and rearrange hoses and cord. Do not use excessive force, as doing so may squash the hoses and lead to incorrect operation.

To prevent kinked hoses Either sit the drawer down on the left hand side  recommended) or rotate the drawer clockwise, resting it on its side after removal.

Install Method B Single - Remove the Lower Drawer.JPG

(3) Press the release tabs in on either side and push back to release drawer from runners.  Lift drawer off runners.

Secure to the Cabinetry on the Sides

Refit the Drawer onto the Runners

The product has three pairs of fixing points:

(1) Two pairs of formed brackets on either side of the chassis (use 16 mm screws)

(2) Ensure the sound insulation is repositioned correctly.

(3) A pair of fixing holes either side on the bottom (use 38 mm fixing screws & washers)

Secure to Cabinetry on Sides - Single  (1).JPG

Before refitting the drawer, ensure the hoses are not twisted and the latches at the rear of each drawer runner are facing forward.

Lift or rotate anti-clockwise the drawer back onto the drawer runners on either side.

Refit Drawer onto the Runners - Single.JPG

Pull the release tabs forward on both sides 100 mm. Ensure the tabs are fully pulled forward and click into place.

 

  • Was this article helpful?