Integrated models with badge only - Installing the front panel & badge controls
Details how to install the front panel for integrated model with badge only.
1. Determine badge cutout location
WARNING!
![]() |
Electrical Shock Hazard
|
2. Remove bracket & disconnect badge
![]() |
![]() |
3. Route badge wiring through panel
4. Attach panel to panel bracket
There must be at least 3 screws used each side
Align bottom of panel with bottom of bracket
5. Reattach badge & earth the panel
WARNING!
![]() |
Electrical Shock Hazard
|
6. Attach panel to product
When refitting the door pins, ensure they are orientated as shown.
7. Adjust panel height to align the cabinetry gaps
With the front panel fitted, insert an appropriately sized Philips screwdriver into the hole above the door pin and rotate the panel up or down to align the gaps in your cabinetry.
Repeat on the other side if necessary.
The panel has a maximum travel of 2 mm up or down.
Ensure that you maintain a minimum of 8 mm ventilation gap below the panel.