Skip to main content
Fisher & Paykel Product Help

Integrated models with remote only - Installing the front panel

Details how to install the front panel for integrated model with remote only.

1. Remove bracket from product


Screen Shot 2017-08-03 at 10.29.06 AM.png

Electrical Shock Hazard

  • Before continuing, ensure that the product is disconnected from the power supply.
  • Failure to follow this warning may result in electrical shock, injury or fire.
2017-08-03_1025-fixed1.jpg 2017-08-03_1025-fixed2.jpg

2. Attach panel to panel bracket

There must be at least 3 screws used each side

Align bottom of panel with bottom of bracket

3. Earth the panel


Screen Shot 2017-08-03 at 10.29.06 AM.png

Electrical Shock Hazard

  • To earth the panel bracket, connect the earth wire from the product to one of the tabs.
  • Any custom metal component (e.g. handle) that extends past the rubber seal must be earthed too.
  • Failure to follow these warnings may result in electrical shock, injury or fire.



4. Attach panel to product


When refitting the door pins, ensure they are orientated as shown.


5. Adjust panel height to align the cabinetry gaps


With the front panel fitted, insert an appropriately sized Philips screwdriver into the hole above the door pin and rotate the panel up or down to align the gaps in your cabinetry. Repeat on the other side if necessary.

The panel has a maximum travel of 2 mm up or down.


Ensure that you maintain a minimum of 2 mm ventilation gap below the pane