Skip to main content
Fisher & Paykel Product Help

Integrated Models with Remote (NZ AU) ONLY - Installing the Front Panels

Details how to install the front panel for integrated model with remote only.


1. Remove bracket from product


Screen Shot 2017-08-03 at 10.29.06 AM.png

Electrical Shock Hazard

  • Before continuing, ensure that the product is disconnected from the power supply.
  • Failure to follow this warning may result in electrical shock, injury or fire.


Repeat for the other drawer



2. Attach panel to panel bracket 

There must be at least 3 screws used each side


Break off and discard the tab at the top of the Lower Panel Bracket.


Align bottom of panels with bottom of brackets


3. Earth the panel 


Screen Shot 2017-08-03 at 10.29.06 AM.png

Electrical Shock Hazard

  • To earth the panel bracket, connect the earth wire from the product to one of the tabs.
  • Any custom metal component (e.g. handle) that extends past the rubber seal must be earthed too.
  • Failure to follow these warnings may result in electrical shock, injury or fire.


Repeat for the other drawer


4. Attach panel to product

Ensure the rubber seal between the drawer and panels is kept in place.


Repeat for the other drawer


When refitting the door pins, ensure they are orientated as shown.


5. Adjust panel height to align the cabinetry gaps


With the front panel fitted, insert an appropriately sized Philips screwdriver into the hole above the door pin and rotate the panel up or down to align the gaps in your cabinetry.

Repeat on the other side if necessary.

The panel has a maximum travel of 2 mm up or down.


Ensure that you maintain a minimum of 8 mm ventilation gap below the pane


6. Fitting a custom toekick panel

You can optionally glue your custom toekick panel onto the supplied panel.

  • Was this article helpful?