Skip to main content
Fisher & Paykel Product Help

Fit the Supplied Toekick Panel (DD60DA & DD60DC models only)

Fit the supplied toekick panel - DD60DA Models Only


Measure how high the toekick should be based on min. 12 mm clearance to floor and the table below.

 

Height From Floor to Bottom Of Door (mm)

Number of Cutoff Sections to Remove from Panel

100-114

3

115-129

2

130-144

1

145-160

0

 


 

On a board, lay the toekick on its side and carefully score/cut down the corner to where the cutoff will be. There are 3 preset height positions.
Carefully bend and snap off the side.
Repeat in the opposite corner.

 

Once the sides are removed, score/cut all the way down the middle of the toekick.

 


Carefully bend and snap off.

 

Using a hammer and screwdriver, punch out the two mounting hole locations as shown.
Repeat on the opposite side.

Use a file to smooth the top edges.

 

Mount the toekick into position over the cowling. Ensure the holes in the toekick match up with the mounting hole positions on the cowling. Push the two pins in to secure. 
Repeat on the opposite side.
 

if after fitting, the drawer touches the floor with a full load, you need to remove more of the toekick panel:

  1. Remove the lower drawer (see ALTERNATIVE METHOD (B) - SECURE BY DRAWER REMOVAL - STEP 8 B: REMOVE THE LOWER DRAWER)
  2. Remove the pins - use a pair of needle nose pliers to press the pin legs together and push back through the hole
  3. Remove the panel, and cut off another section of the kick strip following steps 2-8 above.
  4. Replace the drawer (see ALTERNATIVE METHOD (B) - SECURE BY DRAWER REMOVAL - STEP 11 B REFIT THE DRAWER ONTO THE RUNNERS)
  5. Continue from step 7 above.

 

Fit the supplied toekick panel - DD60DC Models Only


Where the toekick meets the bottom of the tub is the cut-off point

Mark this point on the toekick with a pencil


Lay the toekick face down on a chopping board or similiar

Score along the marked cutoff line with a knife

Turn the toekick over and score along the same line

Gently snap off the excess

Smooth the edges with a file. Be careful of sharp edges.

Snap off the two end tabs

Slide the toekick onto the mounting rails either side and screw the toekick onto the bottom of tub on either side

Do not overtighten screw.

  • Was this article helpful?