Skip to main content
Fisher & Paykel Product Help

Flush Mounting Installation (optional)


Flush Mounting #1.PNG


Refer to ‘When you you install the appliance’ in the Safety and Warnings section before you flush mount this appliance.

Flush Mounting #2.PNG


Flush Mounting #Rear.PNG


Electrical connection is made at the right rear.

Flush Mounting #Side.PNG


Flush Mounting Front.PNG



Product and Cabinetry Dimensions mm
A. Overall height of product (excluding burners, dials and pan supports) 79
B. Overall width of product 900
C. Overall depth of product 530
D. Height of chassis (below top of counter) 76
E. Width of chassis 860
F. Depth of chassis 487
G. Overall depth of routered recess 905
G1. Width of cutout 875
H. Overall depth of routered recess 535
H1 Depth of cutout 494
I. Corner radius of cutout 10
J. Corner radius of routered recess max. 5
K. Height of routered recess 3
L. Distance from top of counter to center of gas inlet on product 76
M. Distance from edge of chassis to gas inlet on product 22
N. Minimum clearance below top of benchtop to:
  • Rear top of oven* installed below cooktop or
  • Cabinetry thermal protection barrier


A. Router the Benchtop to the specified Depth.

Screen Shot 2018-01-04 at 3.47.17 PM.png

B. Fit the Clamping Brackets.

Screen Shot 2018-01-04 at 3.47.25 PM.png

C. Mask the Area to be Siliconed.

Screen Shot 2018-01-04 at 3.47.31 PM.png

D. Apply Silicone.

Screen Shot 2018-01-04 at 3.47.54 PM.png

E. Wipe off excess Silicone.

Screen Shot 2018-01-04 at 3.47.47 PM.png

F. If removing product, Cut around the silicone.

Screen Shot 2018-01-04 at 3.47.39 PM.png

  • Was this article helpful?