Skip to main content
Fisher & Paykel Product Help

Connect to Gas Supply

 

NG Models

LPG Models


If converting to LPG, see 16 'Converting to a different gas type'

Screen Shot 2018-01-04 at 3.59.54 PM.png
  • Adjust to obtain a test point pressure of 20 mbar with all the burners operating at highest setting.
Screen Shot 2018-01-04 at 4.00.00 PM.png
  • Make sure the supply pressure is regulated to 29 mbar, with all the burners operating at highest setting.

All Models

  • Make sure the connection point will be accessible with the cooktop installed.
  • To enable the gas supply to be readily shut o by the customer, make sure the connection is fitted with an isolating valve close to the cooktop.
Screen Shot 2018-01-04 at 3.59.49 PM.png

If Connecting the Gas with a Flexible Hose: 

  • Ensure the hose is long enough to allow for removal of cooktop for servicing.
  • Make sure the connector is located as shown in step 5 CLEARANCE DIMENSIONS.
  • Hose assembly must be AS/NZS 1869 Class B or D certified, with an Rp 1⁄2” (ISO 7‐1) female thread connection.
  • Hose assembly must be as short as practicable and comply with relevant AS 5601/NZS 5261 requirements.
  • Hose must not be kinked, subjected to abrasion or permanently deformed.
  • Hose must not be near or in contact with any hot surfaces(e.g. base of metal hot plate, flue, or chassis of under bench oven etc.)
  • Was this article helpful?