Choose your Installation Method A or B

Attach Side Mounting Brackets

Clip all four side mounting brackets into their slots using a flat-bladed screwdriver. Ensure they’re securely fitted before sliding product into cavity.

The mounting slots are in pairs, one on each side diagonally across the product. A bracket must match A slot and B bracket must match B slot.

When fitting brackets, ensure the ends are not pushed down into the chassis.

Pull Through Hoses & Push into the Cavity

As you push product in, pull through hoses and cord, ensuring they don’t get kinked or twisted.

If product cannot be pushed in far enough, pull out again and rearrange hoses and cord. Do not use excessive force, as doing so may squash the hoses and lead to incorrect operation.

Secure to the Cabinetry on the Side

Pull Through Hoses & Push into the Cavity

 

As you push product in, pull through hoses and cord, ensuring they don’t get kinked or twisted.

If product cannot be pushed in far enough, pull out again and rearrange hoses and cord. Do not use excessive force, as doing so may squash the hoses and lead to incorrect operation.

Remove the Lower Drawer

 

To prevent kinked hoses Either sit the drawer down on the left hand side  recommended) or rotate the drawer clockwise, resting it on its side after removal.

Press the release tabs in  on either side and push back to release drawer from runners.  Lift drawer off runners.

 

Secure to the Cabinetry on the Sides

The product has three pairs of fixing points:

Refit the Drawer onto the Runners