Skip to main content
Fisher & Paykel Product Help

Installing Custom Front Drawer Panels

 

 

 

WARNING! 

Electric Shock.PNG

Electric Shock Hazard

  • Before continuing, ensure that the product is disconnected from the power supply.
  • Failure to follow this warning may result in electrical shock, injury or fire.

 

Remove Both Panel Brackets from Product

Install Custom Front Drawer Panels_Double #1.JPG

Remove side pins and gently pull off the panel bracket slightly.
Repeat for the other drawer.

Install Custom Front Drawer Panels_Double #2.JPG

Disconnect the Earth Wire from the bracket.
Unplug the Knock-to-Pause module from the controller.
Repeat for the other drawer.

Remove the Knock-To-Pause Module

Install Custom Front Drawer Panels_Double #3.JPG

Remove the Knock-to-Pause module from the back of the bracket.
Repeat for the other bracket.

Attach Custom Panels to Panel Brackets

Install Custom Front Drawer Panels_Double - Attach Custom Panels.JPG

Break off and discard the tab at the top of the Lower Panel Bracket.

Attach Knock-To-Pause Modules to Custom Panels

Install Custom Front Drawer Panels_Double - Attach Knototpause Modules3.JPG

  • Ensure the Knock-To-Pause module is orientated correctly before attaching.
  • Ensure the module is centralized in the holes and not in  contact with the bracket.

Attach the Knock-To-Pause module to the back of the custom panel through the 3 holes cut into the panel bracket as shown. 
Use all 3 screws provided. 

Repeat for the other module.

Connect the Knock-To-Pause Module to the Controller

 

Install Custom Front Drawer Panels_Double - Connect the knockto pause module.JPG

Repeat for the other drawer.

Reconnect the Earth Wire to the Panel Bracket

WARNING! 

Electric Shock #2.PNG Electrical Shock Hazard
  • To earth the panel bracket, connect the earth wire from the product to one of the tabs.
  • Any custom metal component (e.g. handle) that extends past the rubber seal must be earthed too.
  • Failure to follow these warnings may result in electrical shock, injury or fire.

 

Install Custom Front Drawer Panels_Double - Reconnect the Earth Wire.JPG

Reconnect the Earth Wire to the Panel bracket.
Repeat for the other drawer.

Attach Custom Panels to Product

Install Custom Front Drawer Panels_Double - Attach Custom Panels to product.JPG

Push the Custom Panel on to the drawer and reinsert the side pins on each side.
Repeat for the other drawer.

Adjust Custom Panel Height to Align Cabinetry Gaps

With the front panels fitted, insert an appropriately sized Philips screwdriver into the hole above the side pin and rotate the panels up or down to align the gaps
in your cabinetry.
Repeat on the other side if necessary.
Each panel has a maximum travel of 2mm up or down.

Ensure that you maintain a minimum of 8mm ventilation gap between the upper and lower panels.

Install Custom Front Drawer Panels_Double - Adjust Custom Panel Height.JPG 

 

 


 

  • Was this article helpful?