Installation Method
Now choose which installation method (A) OR (B) is more suitable for your cabinetry...
Recommended Method (A) - Secure without drawer removal (Frameless cabinetry only)
1-A. Attach side mounting brackets
Clip all four side mounting brackets into their slots using a flat-bladed screwdriver. Ensure they’re securely fitted before sliding product into cavity.
The mounting slots are in pairs, one on each side diagonally across the product. A bracket must match A slot and B bracket must match B slot.
2-A. Pull through hoses & push into the cavity
3-A. Secure the cabinetry on the sides
4-A. Optionally secure to the cabinetry above
The top mounting brackets will only bend upwards a maximum of 10mm.
5-A. Fit the supplied toekick panel (Optional for integrated models)
Where the toekick meets the bottom of the tub is the cut-off point Mark this point on the toekick with a pencil |
Lay the toekick face down on a chopping board or similiar |
Score along with a knife |
Turn the toekick over and score along the same line |
Gently snap off the excess |
Smooth the edge with a file. Be careful of sharp edges. |
Snap off the two end tabs |
Slide the toekick onto the mounting rails either side and screw the toekick onto the bottom of tub on either side.
Do not overtighten screw.
Alternative method (B) - Secure by drawer removal
1-B. Pull through hoses & push into the cavity
2-B. Remove the lower drawer
Press the release tabs in on either side and push back to release drawer from runners. |
To prevent kinked hoses, we recommend rotating the drawer anti-clockwise and resting it on its side after removal. Push drawer runners back in. |
3-B. Secure to the cabinetry on the sides
4-B. Optionally secure to the cabinetry above
The top mounting brackets will only bend upwards a maximum of 10mm.
5-B. Refit the drawer onto the runners
6-B. Fit the supplied toekick panel (Optional for integrated models)
Where the toekick meets the bottom of the tub is the cut-off point
|
Lay the toekick face down on a chopping board or similiar |
Score along with a knife |
Turn the toekick over and score along the same line |
|
Smooth the edge with a file. Be careful of sharp edges. |
Snap off the two end tabs |
Slide the toekick onto the mounting rails either side and screw the toekick onto the bottom of tub on either side.
Do not overtighten screw.