How the fabric softener is dispensed
The fabric softener goes into the dispenser cup on the top of the agitator. During the rinse the machine spins to release the fabric softener, delivering it down the agitator stem as the machine fills for the final deep rinse.
If fabric softener is not added to the washer correctly, it may contribute to ‘scrud’ (described below).
The ‘Bulky’ and ‘Quick’ cycles and ‘Eco Rinse’ option are not designed to be used with fabric softener as the fabric softener will not be dispersed correctly.
How much fabric softener?
Always follow the manufacturer’s recommendations on the fabric softener packaging for the correct dosage.
The ring on the dispenser cup is a guide only for the maximum amount of fabric softener to add for a full load. Smaller loads require less fabric softener.
Cleaning the dispenser
When using fabric softener, rinse your dispenser at the end of each wash.
To separate, push cup away from dispenser with thumb
Scrud is the name given to the waxy build-up that can occur within a washer when the fabric softener comes into contact with detergent. This can happen when fabric softener is not added to the machine correctly. This build-up is not brought about by a fault in the machine. If scrud is allowed to build up in the machine, it can result in stains on your clothes and/or an unpleasant smell in your washer.
If you wish to use fabric softener we recommend:
- Using fabric softener sparingly.
- When filling the dispenser, do not splash or overfill.
- Clean the dispenser as soon as the cycle has finished.
- Clean your machine regularly (refer to the ‘Caring for your washer’ section).
- Cold water washing increases the chance of a build-up of scrud occurring. We recommend a ‘Warm’ or ‘Hot’ wash at regular intervals, eg approximately every 5th wash.
- Fabric softener of a thinner consistency is less likely to leave residue in the dispenser and contribute to a build-up.