Skip to main content
Fisher & Paykel Product Help

Choose your Installation Methods A or B

 

(Frameless Cabinetry Only)

Install Method A.JPG

Attach Side Mounting Brackets

Clip all four side mounting brackets into their slots using a flat-bladed screwdriver. Ensure they’re securely fitted before sliding product into cavity.

Install Method A - Attach side brackets.JPG

When fitting brackets, ensure the ends are not pushed down into the chassis.

 

Pull Through Hoses & Push Into the Cavity

Install Method A - Pull through hoses.JPG

Secure to the Cabinetry on the Sides

Install Method A - Secure Cabinetry on sides.JPG

Optionally Secure to the Cabinetry Above

Install Method A - Optionally Secure to cabinetry above.JPG

After Securing, Depending on your Model - Refer to Relevant "Fit the Supplied Toekick Panel" Step.

 

Alternative Method (B) - Secure by Drawer Removal

Alt Meth B - Secure by Drawer Removal.JPG

Pull Through Hoses & Push into the Cavity

Install Method B - Pull through hoses.JPG

Remove the Lower Drawer

Install Method B - Remove the Lower Drawer.JPG

Secure to the Cabinetry on the Sides

Install Method B - Secure to the Cabinetry.JPG

Optionally Secure to the Cabinetry Above

Install Method B - Optionally Secure to cabinetry above.JPG

Refit the Drawer onto the Runners

Install Method B - Refit the Drawer onto the runner.JPG

Fit the Supplied Toekick Panel

Where the toekick meets the bottom of the tub is the cut-off point.

dd60dc fit the toekick (1).JPG

 

Mark this point on the toekick with a pencil.

 

dd60dc fit the toekick (2).JPG

Lay the toekick face down on a chopping board or similiar.

dd60dc fit the toekick (4).JPG

Turn the toekick over and
score along the same line.

dd60dc fit the toekick (6).JPG

Smooth the edges with a file.
Be careful of sharp edges.

dd60dc fit the toekick (8).JPG

Slide the toekick onto the mounting rails either side and screw the toekick onto the
bottom of tub on either side.

Do not overtighten screw.

 

dd60dc fit the toekick (3).JPG

Score along the marked cutoff line with a knife.

dd60dc fit the toekick (5).JPG

Gently snap off the excess.

dd60dc fit the toekick (7).JPG

Snap off the two end tabs.

 

  • Was this article helpful?